Both patterns zigzag, both look identical in a phone photograph. The difference sits at the point where two staves meet, and it takes a second to see once you know where to look.
The difference at the joint
Herringbone. The staves are rectangular, cut off square, and they meet at a right angle. The end grain of one stave butts against the long side of the next. That produces a step, and the row shifts by one stave length each time.
Chevron. The staves are mitred at the ends, usually at forty five or thirty degrees. They meet point to point and form a continuous line running down the room like a V. No step, a clean seam.
The test takes two seconds. Stand in the middle of the room and look at the centre line of the pattern. If it is a straight joint, it is chevron. If it is a zigzag staircase, it is herringbone.
What actually lies in Vienna
In the Viennese Gründerzeit herringbone is the normal case. Chevron is French, there it is called point de Hongrie, and here it turns up almost only in flats that were converted later, or in floors laid in the last twenty years.
So if you view a period flat and find chevron, you are usually not looking at the original floor but at a renovation. That is not a fault, but it tells you something about the age of what is under your feet, and about how often somebody has already been down there.
Alongside that there is panel parquet, squares with an inlaid pattern, mostly in the formal rooms facing the street. And there is plain strip parquet, the simple version for the kitchen and the back room.
What it costs to bring one back
The figures below are guide prices for Austria, 2026, including VAT and materials.
- Sanding only, with no new finish, fifteen to twenty five euro per square metre.
- Sanding and sealing, lacquer in several coats, thirty six to sixty euro.
- Sanding and oiling, clear, thirty eight to fifty five euro. With a pigmented two component oil, forty five to seventy.
- Re-oiling without sanding, eight to fifteen euro. Only possible if the floor was oiled before.
- Many repairs or an elaborate colour build up, sixty to a hundred euro.
For herringbone and for panel parquet, count on the upper end of every range. The reason is simple, the machine cannot run in one direction, because the grain changes every twenty centimetres. It is sanded diagonally and worked by hand in the corners, and that takes time.
Missing staves are charged by the hour plus materials, thirty to fifty euro net per hour. That is the item no quotation can price exactly in advance, because how many staves are really missing only shows once the carpet and the glue are off.
Three things we check before you buy
- How much wear layer is left. Old solid staves take four or five sandings. If it has been done three times already, the tongue is exposed and the floor is finished.
- Is it drumming. Knock with a knuckle. It sounds dull where the stave is still glued and bright where it has come loose. Loose areas have to be re-bonded before anyone sands.
- Is there water damage. Dark rims along an outside wall or next to the bathroom cost more than anything else, because usually the sub floor has to go too.
Why we almost always oil
Lacquer lays a film over the wood. It lasts a long time, and once it is through, the whole floor has to be done again. Oil goes in. It looks matter, it feels like wood, and a damaged spot can be repaired locally without it showing.
In a flat with children and a dog, that is the difference between a floor that gets replaced in ten years and one that gets oiled again once in ten years.
Sources
Price ranges for Austria 2026 · hausbaumagazin.at
Floor renovation price list 2026 · gecheckt.at
These are guide prices. What your floor costs is known after the survey and not before.